unScanny Resemblance!

The place to show off your epic printing projects. (Pictures or it didn’t happen!)

Moderator: Elijah

LaserGnomes
Posts: 1058
Joined: Thu Dec 06, 2012 10:15 pm

unScanny Resemblance!

Postby LaserGnomes » Tue Dec 31, 2013 4:20 pm

Sense scanner
Zbrush treatments
Series 1 - 0.15mm, Gold PLA (inventables), 16 hour print time @ 50mms


Need 4 of these guys. Trying some various settings for these larger models lead to some interesting effects.

Firstly.. if you are the blessed 2-5 people that still own a Beta Dual extruder..you probably know about how it pushes PLA at 155 and burns it at 180. You'll note one of these statues was printed using GCO meant for one printer on another.

Secondly you might notice the magic trick failure. Not sure why that one had such a large skip in the X. Bearings are fine, have printed a full statue previously with no issue... then this.. then a perfect one using the exact same GCO, same filament, same roll, etc. Very odd.

-LG
Attachments
Antonio.jpg
Antonio.jpg (113.17 KiB) Viewed 2743 times
IMG_7474.JPG
IMG_7474.JPG (1.74 MiB) Viewed 2746 times
IMG_7472.JPG
IMG_7472.JPG (1.85 MiB) Viewed 2746 times

Return to “Projects”

Who is online

Users browsing this forum: No registered users and 1 guest