The place to show off your epic printing projects. (Pictures or it didn’t happen!)
7 posts • Page 1 of 1
Thought this design was pretty amazing, and I love printing assemblies all at once. Sliced with KISSlicer using the inset surface at 0.1mm (I think) as I needed more clearance. Here's a link to the model:
- gear_bearing.jpg (587.65 KiB) Viewed 3823 times
That looks like a nice finish on that piece. Did you have to use support for the hair curls? If so, how did you clean it up after? I've never done anything like that so I'm curious how you got it to look so nice.
Who is online
Users browsing this forum: No registered users and 1 guest