Tool Wall for garage

The place to show off your epic printing projects. (Pictures or it didn’t happen!)

Moderator: Elijah

Fast one
Posts: 57
Joined: Fri Feb 20, 2015 12:24 pm

Tool Wall for garage

Post: #9814 Fast one
Sun Apr 10, 2016 4:33 pm

This took a while because each holder was specific to the tool it holds but all the work was worth it. I don't have time to open and close drawers on tool boxes, if for example a 1/2" wrench is needed they are all in line under the size label. Inch sizes are in white, metric in gray and Torx in blue. The 1/2" drives are in white, 3/8" in green and 1/4" in yellow.
Here's the finished project without the tools, all the 3d printed parts are mounted on a 3/4" thick maple plywood covered with white formica.
Image

Here are the tools in place, most tools are held in their holder using 1/8" x 1/8" or 5mm x 5mm neodymium cylinder magnets; all the holders are attached to the main board with #6 wood screws.
Image

Elijah
Site Admin
Posts: 766
Joined: Wed Oct 10, 2012 6:33 pm

Re: Tool Wall for garage

Post: #9821 Elijah
Wed Apr 13, 2016 4:39 pm

You're prolific! Can I share this one as well!?
Elijah Post
Type A Machines

Fast one
Posts: 57
Joined: Fri Feb 20, 2015 12:24 pm

Re: Tool Wall for garage

Post: #9845 Fast one
Fri Apr 15, 2016 3:46 pm

Sure.

Trilo
Posts: 10
Joined: Tue May 03, 2016 2:59 pm
Location: San Francisco, California
Contact:

Re: Tool Wall for garage

Post: #9899 Trilo
Wed May 04, 2016 12:37 pm

Very cool project!

Espen
Posts: 58
Joined: Thu Oct 11, 2012 11:12 pm
Location: San Francisco, CA
Contact:

Re: Tool Wall for garage

Post: #10031 Espen
Mon May 23, 2016 4:36 pm

This is awesome.

Fast one
Posts: 57
Joined: Fri Feb 20, 2015 12:24 pm

Re: Tool Wall for garage

Post: #10048 Fast one
Tue Jun 14, 2016 7:02 am

After two months of use I really like this design, finding the right tool is fast and easy. So far the tape measure has been the most used and no tools have been lost.


Return to “Projects”

Who is online

Users browsing this forum: No registered users and 2 guests