Yet another spool mount

Share any mods you have made and the awesome results.

Moderator: Elijah

DmitryStu
Posts: 14
Joined: Fri Jun 07, 2013 1:08 pm

Re: Yet another spool mount

Postby DmitryStu » Sun Jun 30, 2013 12:45 am

jd_3d wrote:
DmitryStu wrote:PPS. The THF is very good solvent for PLA


Can you tell me where you bought your THF? I read the post on Protoparadigm's blog, but wasn't able to find a source of THF w/ inhibitors that would sell to non-commercial (Amazon had some, but they would not ship to residential).

Thanks!

-Jonas

I've bought it in our local chemical store, but i'm outside USA.

dsp39
Posts: 96
Joined: Fri Jan 25, 2013 9:25 am
Location: Portland, OR

Re: Yet another spool mount

Postby dsp39 » Tue Jul 23, 2013 8:59 am

Do you still need spool diameters? I re-modeled your spool mount to fit my larger ID and OD spools. Great design!!

DmitryStu
Posts: 14
Joined: Fri Jun 07, 2013 1:08 pm

Re: Yet another spool mount

Postby DmitryStu » Fri Jul 26, 2013 1:43 pm

Sure. The largest OD is most important. Now it can hold up to 250mm spools.
Posted V2 here
PS. Tried to load it by 4 colored spools. Looks great.


Return to “Mods”

Who is online

Users browsing this forum: No registered users and 1 guest