Share any mods you have made and the awesome results.
4 posts • Page 1 of 1
I had a different version of this on my G1 extruder and it keeps the filament from rubbing on the "X" rail while printing. It's a nice simple upgrade if you haven't made one yet. There's a few out there, but this one was designed to fit in better with the lines of the machine and it prints cleanly without supports. It would probably look better in white... I posted all the files to build it here: https://grabcad.com/library/restyled-fi ... extruder-1
- BKS G2 Filament Guide.jpg (31.11 KiB) Viewed 1725 times
- BKS Filament Guide Installed.jpg (119.43 KiB) Viewed 1725 times
Who is online
Users browsing this forum: No registered users and 1 guest