New Wire paths for DE edition

Share any mods you have made and the awesome results.

Moderator: Elijah

LaserGnomes
Posts: 1058
Joined: Thu Dec 06, 2012 10:15 pm

New Wire paths for DE edition

Postby LaserGnomes » Tue Feb 12, 2013 12:37 am

We recently revisited the stock wiring pathways.

After some dilberation we've opted to isolate each extruders set of wires bringing them up the sides and into a Y directly in the middle.

We intend on designing a new fan housing which will
- Have two fans
- Directed air flow
- A bumper to stop the wire harness from progressing into the X plane thereby possibly interfering with the filament top feed we have.

Photoblog via facebook here - > http://ow.ly/hDoS1

Return to “Mods”

Who is online

Users browsing this forum: No registered users and 1 guest