People have been asking, so:
To adjust the height of the first layer:-
At the back of the platform, above the nameplate there is a thumbscrew. This thumbscrew is the trigger for the Z endstop. By adjusting the thumbscrew you move the Z-zero point up or down. Screw it down to move the nozzle closer to the platform for the first layer, up to move it further away!
Rev B machines also have the endstop mounted on bolts in slots, so you can move the endstop to make large adjustments to the zero point.
The place to share your best tips and tricks for the best prints.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest