PLA Prints that stick great to unheated platform

The place to share your best tips and tricks for the best prints.

Moderator: Elijah

Hanaleiguy
Posts: 8
Joined: Fri May 29, 2015 6:08 pm

PLA Prints that stick great to unheated platform

Post: #9288 Hanaleiguy
Mon Sep 14, 2015 12:54 pm

Masking tape 1/8" Plexigass to glass platform and level
Take off, go outside spray 3M Super 77 spray adhesive on it
Retape to unheated platform
PLA loves this stuff!
Easy removal, acetone clean-up if needed at all.

Return to “Tips and Tricks”

Who is online

Users browsing this forum: No registered users and 1 guest