So, I installed the Cura 1.4.1 found in https://bitbucket.org/typeamachines/cur ... _amd64.deb with "sudo dpkg -i ./Downloads/cura_1.4.1-debian_amd64.deb" followed by "sudo apt-get install -f" to fix any dependencies. Then I click on the Ubuntu Button / BFB and type "Cura" which dutifully presents me the application option to click on. When I do so, the Cura Type A Machines orange splash box comes up, bu the application itself never launches. I currently have a workaround bouncing STLs off a Windows install and using it to get GCode onto my S1P, but I'd like a 1 box solution where I run my FreeCAD instance.
Anybody else run into this? Did I do something wrong? Any suggestions where to go looking through logs for the culprit (aside from the standards which I, admittedly, haven't done yet in the hopes somebody has already seen this and knows the fix)?
Discuss Cura Type A, our fork of the Cura slicing software, here. Unstable releases may be made available in this section.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests