Page 2 of 2

Re: Welcome! configs and firmware

Posted: Mon Feb 18, 2013 3:07 pm
by LaserGnomes
pwiseman wrote:It's the default slic3r profile, supplied by TAM.


Yeah just saying they should check it, make changes if needed, upload new file.

All the hot ends are the same so the default extrusion width should be >0.35m but certainly not as as high as 1.0mm. Something that high is sure to result it bad prints (3x tip diameter)

We just started digging back into other slicers and thought to see what the Make Test was about and what files they would have used... discovered what we would call poor settings. Not that we are pros or anything just from using this machine specifically.

- 2 cents.

Re: Welcome! configs and firmware

Posted: Tue Oct 13, 2015 11:59 am
by Matthew
pwiseman wrote:
It's the default slic3r profile, supplied by TAM.

As far as I know, Type A Machines has never officially supported Slic3r. They used KISSlicer for the 2013 machines, and Cura for the 2014 and 2015 machines.

-matthew-

Re: Welcome! configs and firmware

Posted: Fri Nov 06, 2015 5:43 pm
by Elijah
Speaking as employee no. 1,

We did way back in the day, but around the time we shipped the dual-head test batch, we switched to KISS