Welcome! configs and firmware

Welcome to the great dual head experiment. Type A has joined the special club of companies with dual extrusion machines in the wild.

Join us in making them more awesome, and share your results and ideas here.

Moderator: Elijah

Posts: 1058
Joined: Thu Dec 06, 2012 10:15 pm

Re: Welcome! configs and firmware

Postby LaserGnomes » Mon Feb 18, 2013 3:07 pm

pwiseman wrote:It's the default slic3r profile, supplied by TAM.

Yeah just saying they should check it, make changes if needed, upload new file.

All the hot ends are the same so the default extrusion width should be >0.35m but certainly not as as high as 1.0mm. Something that high is sure to result it bad prints (3x tip diameter)

We just started digging back into other slicers and thought to see what the Make Test was about and what files they would have used... discovered what we would call poor settings. Not that we are pros or anything just from using this machine specifically.

- 2 cents.

Posts: 126
Joined: Wed May 14, 2014 12:40 pm

Re: Welcome! configs and firmware

Postby Matthew » Tue Oct 13, 2015 11:59 am

pwiseman wrote:
It's the default slic3r profile, supplied by TAM.

As far as I know, Type A Machines has never officially supported Slic3r. They used KISSlicer for the 2013 machines, and Cura for the 2014 and 2015 machines.

I'm from support. I'm here to help.

Site Admin
Posts: 767
Joined: Wed Oct 10, 2012 6:33 pm

Re: Welcome! configs and firmware

Postby Elijah » Fri Nov 06, 2015 5:43 pm

Speaking as employee no. 1,

We did way back in the day, but around the time we shipped the dual-head test batch, we switched to KISS
Elijah Post
Type A Machines

Return to “Dual Head”

Who is online

Users browsing this forum: No registered users and 1 guest