All general topics and questions.
3 posts • Page 1 of 1
Hi all. I'm printing a part with a long, thin rectangular cross section (~25 x 280 mm) on my series 1 pro. I've been having lots of issues with my extruder motor skipping and causing inconsistent (material missing due to skip) or failed prints. I've replaced the driver and the jumper cable for the extruder in the e-tray, but I'm still having the same issue. I am currently attempting to print the part again, and I've noticed that the skipping doesn't seem to happen when the layer has been sliced in such a way that the hot end makes many short passes; however, when it prints the next layer and makes long, straight runs it skips very frequently. Also, once the shell is printed and it begins printing infill (so more short passes) I don't see the skipping, but when it prints the perimeter (long, continuous path) it begins skipping again. Any ideas or suggestions?
Who is online
Users browsing this forum: No registered users and 3 guests