Search found 744 matches

by LaserGnomes
Sun Jan 13, 2013 12:08 am
Forum: General Discussion
Topic: New and Improved Spool Holder
Replies: 13
Views: 5054

Re: New and Improved Spool Holder

We are currently printing this file as well. We'll upload our results from the different software options. We use the same model # tape but not the "EL" or edge lock... the prints lift pretty much right off with a small out of razor prying. We've been able to reuse the same tape job 2-4 ti...
by LaserGnomes
Sat Jan 12, 2013 10:41 pm
Forum: Tips and Tricks
Topic: Watch the filament and extruder assembly
Replies: 1
Views: 1224

Re: Watch the filament and extruder assembly

This exactly happened to TWO of our connectors ends. It appears to be a mix of slackless connectors and overzealous crimping. Easy fix if you have the proper crimping tool, some solder and time. We thought to inject some hotglue into the connectors to give them an alternate point of tension other th...
by LaserGnomes
Sun Dec 30, 2012 5:07 pm
Forum: Tips and Tricks
Topic: Air Powered Cleaning
Replies: 1
Views: 1146

Air Powered Cleaning

Short story. We had a jam of orange pla. Swapped to white. 400mm of filament later there is still orange mixed in. Off to the music store for a wire... Presto! Clog cleared.. back in business... wait.. .what is this.. MORE ORANGE... Enter CAN O AIR. We just put the red straw almost flush with the fi...
by LaserGnomes
Thu Dec 06, 2012 10:16 pm
Forum: Dual Head
Topic: Welcome! configs and firmware
Replies: 12
Views: 13632

Re: Welcome!

...exactly what I was looking for. THANKS!

Go to advanced search